Jump to content

Quadra 752i tipping


golf-mass

Recommended Posts

Just broke my 8 iron shaft , is it possible to use my 4 iron shaft tipped to 8 iron length ?

Link to comment
Share on other sites

Flex would not even be close.

As with most high end shafts, tip tipping is not recommended.

Compare/match up graphics and see if butt trim is the way to go

I'm not an expert in this field but I do believe I'm right on this one...

Anyone else?

Link to comment
Share on other sites

In theory, you might/should be able to (always good to double check with the manufacturer or experts). The tip size of the 725is are listed as parallels (.370). Taper tips (.355) are a whole different story...

Link to comment
Share on other sites

Flex would not even be close.

As with most high end shafts, tip tipping is not recommended.

Compare/match up graphics and see if butt trim is the way to go

I'm not an expert in this field but I do believe I'm right on this one...

Anyone else?

I was comparing the graphic , if I tipped my 4i shaft by 2 inches , it is to 8i length n all the graphic are in line . It 0.37 tip and was wondering is the shaft if tipped will perform to actual 8i . Thanks for all feedback

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...