joey3108

Soft step twice aproximately will have 1/2 flex softer. However if you said PX 6.0 is a hair to soft, you might want to consider just soft step once. Joe

If you are thinking of flattening up your ball flight and hit it a hair lower, then you might want to try the SC...vice versa on the TW. Joe

TW is midlow and SC is midhigh kick point shaft. Joe

why would you consideRing two totAlly different spec shaft? OBVIOUSLY IF THE SHAFT SPEC FIT W/ YOUR SWING PROFILE AND CLUB HEAD SPEC, IT SHOULD BE GOLDEN. Joe

Don't take a chance! The exposed area has been exposed to heat already, so the chances of snaping it is big. Tipping it to a point where the fresh area to reduce risk is gonna make the shaft play so stiff. Joe

It will be available around March! They will be a little different spec compare to Japan issue. I will know more when i can get a hold of them ASAP. They are in production now and don't know when is the delivery time. Joe

Good for you! Hope everything work out well for you. Good luck! JOe :tsg_smilie_cool:

It's not an easy questions to answer IMO. We can't compare them apple to apple. Obviously he is in England w/ cost of living, expenses and rent are much higher than North Carolina ( just example ). Plus if he is that good and famous, you can't compare the rate of Butch Harmon and some local teaching pro ($500 vs $50 per hr ), even i know a lot of them are as good or maybe even better than any famous teachers out there, But Butch is Butch! If you feel it's to far from your reach, Don't even think twice of going there...on the other hand if you want to give it a try and you have the money to burn, why not? Yes, you are entitle to ask around about his reputation but comparing their rate is like asking Butch why his rate is $500 per hr. Plus I don't think Butch can handle his work if his rate is $50 per hr now, he'll be swamp w/ work. just my 2 cents! Joe

Just make sure you take a note on every heads weight before and after one by one. This way you will know how far the weight change and how bad it will effect the play later. Good Luck! Joe

For hobbiest, This is should be good enough.

Basically you heat up a solution in a tank and dip the prep heads in the tank for the amount of time required depending on size and transfer it to a penetrating oil solution for final step.

Nope this is a hot tank technique. Heat gun can't be this deep black.

THis is the one i did today for a tour player. Joe :tsg_smilie_cool:

I was shock when the customer showed it to me! I've seen to many of them w/ paint chip in the corner of the hosel also. It looks like they are not patient enough and try to yank it to quick or maybe the to much heat till the ferrule collapse/melt and put to much force on the paint. It very important not to let the ferrule collapse/melt to far IMO. Or maybe the fork opening is to wide or not quite 90* angle. O well! :tsg_smilie_rolleyes:

More off set look and Less bounce! Major? Maybe if you are a stip swinger, you will dig the course a bit to much...especially on soft condition courses. joe