bladeceo

I have a car there I am planning to buy and I need someone to go by Audi of Charlotte and check it out for me, Thanks in advance! 334-221-3333 or email me [email protected]

Reports are the pipelines from LA to AL,MS,GA,NC,VA, all the way to NY are at very low capacity. Is you area out of gas yet or being rationed? What are you hearing? This will be very helpful for those who are traveling in the near future.

I unglued a bettinardi putter head and trimed it a 1/2 inch and it tried to reinstall and it was too big( go figure) so I sand belted it some more and it went in but I cant get it to rotate or budge. I tried reheating the head and used the vise all the way tight and no luck. That sucker is stuck but good. Any suggestion would be appreciated. Also what shaft would a hogan bettinardi use that cant be tipped a half inch. Thanks

They should ship today so later this week Im guessing.

Blade Combo is they way to go!! Thin Topline Yes both the cavity and Blade have thin top lines Very Low Offset very little offset Rounded Toe ground to your request A reasonably large cavity (muscle cavity ala TP 2005?) yep Confidence inspiring at address yep custom ground to your specs and dipped in copper fpr incredible feel!!

$575

New price is $625 shipped

New price $650 shipped

$675 OBO ships out next day

My back-up set shafted with S3 Tour concept shafts. Satin Finish 3-PW wedges are raw finish 8.5 /10 condition currently 3/4" long at D5 but can be trimmed to: 1/2" long D3.5 standard length(37.75 five iron) D2 GP tour velevet grips sells new for over $1400 $700 OBO ships out next day These are pics of the satin finish when new. My clubs have some bag wear.

3-PW with GW and SW(GW & SW are raw) included(10 irons) 8.5 condition Shafted with Tour Concept S3 3/4" @ D5 swingweight 1/2" @ D3.5 swingweight Standard length @ D2 swingweight $650 shipped

Thats right! You can buy the X460 for $425 with this $300 shaft that is being used by 4 of the world's top 6 players. Limited time offer so act now!

So, why don't we agree to disagree. haribo I have no problem agreeing to disagree. But then I also did not call you statement BS. as you did mine. That's the only reason I repsonded.

I was personally told the r7 was Beta ad the TP was SP-700 by the Director of TM Metalswood division about 2 months ago. I dont care either way but I'm guessing he would know. BTW a differing Ti metal would not require any different tooling or facilty either

sorry double post