mugsy

i am looking for a set of nippon 1150's in stiff. 3-pw or 3-lw. i would prefer if they were new and uncut. if any one can help me out. please email to [email protected] thank you

i am looking for a r7 tour shallow 9.5 with a square face. just the head or shafted would be fine. thanks for looking.

i am looking for a fujikura pro 95 in stiff uncut. thanks for looking email [email protected]

i have a set of rifle project x 6.0 3-pw for sale. taper tip (.355) only the 6 iron was used for a demo. the rest of the shafts are brand new. the six iron is also 1 inch over standard length. price SOLD.. i also have a set of rifle 6.0 that were pured by golfsmtih. taper tip (.355) they have the alignment sticker on them for installation. same as above the 6 iron was used as a demo. and the rest of the shafts are new. price is $135 shipped. thanks for looking. emails sent to [email protected]

I am looking for a nike ignite tour in 9.5 or 10.5 any size 410 or 460 is ok. thanks

i am looking for a TM 200 tour 15 degrees smooth top. please email me if you have one. [email protected] thanks

pm sent

price drop

i have three scatch wedges for sale, purchased from ari on this site, they are all raw finish. all have dynamic gold S-300 shafts. specs: 54: 14 bounce, D4 56: 12 bounce, D5 60: 10 bounce, D5 56 degree is new SOLD 54, 60 have hit a few balls. $75 each or both for $135 email if interested for pictures. [email protected] thanks

i have been trying to sell these for a while, now i have to resort to ebay. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...=ADME:B:LC:US:1

i found one, thanks for all your replys

i am looking for a tour issued 3 wood, anything but the v steel. pm or email me if you have any. [email protected] thanks

a great answer from a true ho. thanks

thanks for the quick reply, do you think tipping it a half inch would be enough to achieve the right frequency for a 107 mph swingspeed.

i recently got a fuji 660tr. however i noticed there is no indication on the shaft of the flex. the 660 tr is in golf print. can anyone tell me how to tell the difference in shaft flex.

thanks for your help

does anyone know what the insertion depth is for the shaft into the head for the tour v steel. is it 1.25 inches or 1.5 inches.

i have been trying to sell this set for a while on this site, so now i hae to list it on ebay. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...=ADME:B:LC:US:1

i am looking for a set of mizuno mp 37 tour issues. 3-pw. if anyone knows of a set please let me know. [email protected] thanks

i have a 54,56,60 all in raw finish. all new bought on this sight. let me know if you are intersted.

what about miura japan, perhaps the softest and sweetest feeling irons i have ever hit.

sold

price drop, $700 shipped anywhere in the US

the paint break on the tour v steel goes from the hosel down to the heel. the sole purpose of this is to enable you to adjust the lies angles without damaging the paint. there are also no serial numbers on the hosel, and most noticably the face angle is dead square. those are the only noticeable differences.

i am looking for a set of x blades mb. if anyone has a set pm or email me [email protected] thanks