dalillama47

where would these be shipping from?

Standard specs on the irons?

Might take a drive down this road again. I've had the Miura's then sold them but have been intrigued by alot of the Epon and Yamaha comments. I'm a digger and live in the North East in the US. Really liked the Miura's and sold for a set of blades ( Yonex ) which were very good. Just wanting to go back to something with a little forgiveness. Currently have a set of Ping i20's which are very good for my swing ( predominant miss is a toe strike ).

Thoughts on the 11 model v forged?

Wow, no love for Yonex Ezones? Price drop to $800.00

3-pw Ezone mb, 3-pw with the Nippon Modus Tour 120 in stiff flex. Royal sand wrap grips, standard loft and lies, play off of a 38" 5iron. No bag chatter. $835.00 shipped and Paypaled .

Will now consider trades for the following: Epon 302's Yamaha V-forged or tours.

Sent you a PM.

I will now separate the the heads and shafts if I have a buyer for the heads.

How about a reasonable offer. Really would like to move these.

I know i don't have any feedback on this site, but I'm always lurking and have plenty of positive feedback on other forums and ebay, so no worries. Now onto the goods. I have a pristine set of Miura PP 9003 4 & 5 irons and cb-501 6-pw. Shafts are spine aligned Project X PXI 5.5, with Lamkin REL 3 gen gray grips, pro-soft inserts installed. The 4 & 5 irons have been bent 1* weak and all lies are Titleist standard. Irons have 27 holes. Some of the ferrules could be turned down a little more, but no biggie. Irons play off of a 38" 5 iron. You all now how much these would cost you new, especially with these shafts. 1K shipped and Paypaled

Not trying to thread jack, but Chris is there a major difference between the MB 5003 and the older 5002

Chris, it was on the onoff wedsite in English when I was checking out some iron models.

Thank You.

Have been trying to learn as much as possible on the JDM equipment. I was kind of intrigued with the NC-1 irons. Quality, performance, design and craftsmanship, how do these compare to say a Miura 201cb? Who use to do the forgings for Gauge Design?