GregP

Looking for a gap wedge around 50 degrees, although anything between 49-51 is fine. Looking for higher degree of bounce - better for a digger type of swing. Head only is preferred, but of course, shafted can work also. Thank you, Greg

Looking to buy a used Epon AF-101 Driver Head only if possible - 10.5 degree. If shaft is a must, I'm looking for an X Flex shaft, comparable to the Matrix Ozik X-Con 6 X Flex. ~ 70 grams. Thank you in advance! GregP

Price reduced to $650.00

These are by far the most forgiving forged irons I have ever hit. I have two sets so I am going to move this one. They are in excellent condition and only have minor play markings. These irons have been Pro Tuned by protunedgolf.com. If you go to their web site, you can read about their work. The shafts are Project X 6.0 Flighted and the set consists of 3-PW. They are +1/2 inch and 2 degrees upright and have new Tour Velvet Grips installed. 650.00 shipped anywhere in the US Please feel free to email me for any further specs or pics. Thank you! Greg Palmer

Looking for R7 forged heads - I understand these are in short supply. Anyone looking to part with heads only? Thanks for looking! Greg

I picked up a set of the Miura Forged Taylor Made CB's and I want to put Project X Shafts in them. I can't find the specs anywhere. Before I pull them and bring a head to the local golf shop, thought I'd ask - are these .355 or .370? I think they are from 03-04. Thanks, Greg

Okay, thank you!

I am tyring to install an Ozik Xcon shaft into a Ping G5 driver. The Aldila shaft I removed is thicker at the tip than the Ozik shaft. The Ozik shaft seems too thin. Does Ozik make different size tips? Is there anything I can do to use this shaft? Will the epoxy settle in there and hold it in place anyway? Thanks! Greg

I am looking to buy a great Driver head. I have a couple of great shafts to try out in it, so ideally, looking for a head only. My preference is to try an Epon, but I will consider any other great head in 10.5 degree. Thank you! Greg

I just purchased an Xcon 6 to install into either my Ping G5 or a Bridgestone J33R head. Is there a set amount I need to take off the tip? Is there any special prepping of the tip I need to do other than usual with other shafts? Sorry for the stupid questions. Greg

Anyone heard of this company? Is it legitimate? http://www.ikasugolf.com/ I stumbled upon their wedges on ebay and was curious since I haven't seen the name anywhere here in the forum or on the product list. Thanks! Greg

I have read through pretty much every post on wedges, or at least as many as I could find. I am in the market for three new ones, most likely 52, 56, 60 - depending on which iron set I go with. Can anyone enlighten me on Scratch wegdes? I noticed that there were several options in the pro shop. Where to begin? Also, can anyone draw a comparison to the Epon wedges (technicity and X)? Are these two outstanding choices? What else might you recommend. I have been playing with Vokeys for several years and I love them, just would now like that type of performance with a sof feel. Thanks for any help and suggestions.