thehawk Posted October 28, 2004 Report Share Posted October 28, 2004 i have a new never hit Blade X400 8.5 degree driver and the two matching fairway wood models (14 degrees and 18 degrees). they currently have spined std.length/lie X100 spined shafts in them but i could install something to your specs if you contact me. as they are i would sell them all for $210 shipped. these are brand new. Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 8, 2004 Author Report Share Posted November 8, 2004 dropped to $175 for the set. Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 8, 2004 Author Report Share Posted November 8, 2004 tsgolfer, pm sent in reply. Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 24, 2004 Author Report Share Posted November 24, 2004 still have them. $175 for the whole set...brand new. this includes the X400 driver with 8.5 degrees of loft AND the 3&5 woods. Quote Link to comment Share on other sites More sharing options...
fpotter Posted November 24, 2004 Report Share Posted November 24, 2004 What is the length of the driver and 3 wood? Do you know the swingweight? Do they sit square? Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 25, 2004 Author Report Share Posted November 25, 2004 the length are: 8.5degree driver, 44.5''; 3wd, 43''; 5wd, 42.75''. the shafts are standard X100 Dynamic Gold which have been spine aligned to the center. the swingweights are currently at a standard D3. the face angle of the driver is slightly closed. i would say that a guy who hits it straight or is more prone to fading would be fine with this face angle. the fairway woods are currently closed even a tad more than the driver. with this particular shaft, these woods hit a low tradjectory and because of this I would be willing to change the shaft to fit the buyer for a nominal extra fee. for most a lower kick shaft will be needed in these. pretty much any shaft request i can take care of. however, these woods have a hosel that can be adjusted very easily which i would be willing to do OR you could do it yourself so the face angle is just right to your specs. Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 28, 2004 Author Report Share Posted November 28, 2004 i still have this set of woods that i would like to move for $175. look above for spec options. Quote Link to comment Share on other sites More sharing options...
thehawk Posted November 30, 2004 Author Report Share Posted November 30, 2004 i would like to add that i have access to most any shaft out there and i would be willing to install them at cost. if i already have them sitting around i would throw them in at no charge. [email protected] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.