i have a new never hit Blade X400 8.5 degree driver and the two matching fairway wood models (14 degrees and 18 degrees). they currently have spined std.length/lie X100 spined shafts in them but i could install something to your specs if you contact me. as they are i would sell them all for $210 shipped. these are brand new.

dropped to $175 for the set.

tsgolfer,

pm sent in reply.

still have them. $175 for the whole set...brand new. this includes the X400 driver with 8.5 degrees of loft AND the 3&5 woods.

What is the length of the driver and 3 wood? Do you know the swingweight? Do they sit square?

the length are: 8.5degree driver, 44.5''; 3wd, 43''; 5wd, 42.75''.

the shafts are standard X100 Dynamic Gold which have been spine aligned to the center. the swingweights are currently at a standard D3.

the face angle of the driver is slightly closed. i would say that a guy who hits it straight or is more prone to fading would be fine with this face angle.

the fairway woods are currently closed even a tad more than the driver. with this particular shaft, these woods hit a low tradjectory and because of this I would be willing to change the shaft to fit the buyer for a nominal extra fee. for most a lower kick shaft will be needed in these. pretty much any shaft request i can take care of. however, these woods have a hosel that can be adjusted very easily which i would be willing to do OR you could do it yourself so the face angle is just right to your specs.

i still have this set of woods that i would like to move for $175. look above for spec options.

i would like to add that i have access to most any shaft out there and i would be willing to install them at cost. if i already have them sitting around i would throw them in at no charge.

[email protected]