wmclarenf1 Posted January 6, 2012 Report Share Posted January 6, 2012 Thanks in advance. Quote Link to comment Share on other sites More sharing options...
stevopagolf Posted January 6, 2012 Report Share Posted January 6, 2012 .335 I believe Quote Link to comment Share on other sites More sharing options...
wmclarenf1 Posted January 6, 2012 Author Report Share Posted January 6, 2012 .335 I believe I just got the response from PRGR Japan but its in mm which they gave as 9.2mm so converting to inches (i think) it works out to 0.362. Guess I wil lbe going with a 0.37 and file down to fit. Quote Link to comment Share on other sites More sharing options...
pickle Posted January 6, 2012 Report Share Posted January 6, 2012 I've used a standard .355Taper shaft in mine and it worked fine. Quote Link to comment Share on other sites More sharing options...
wmclarenf1 Posted January 7, 2012 Author Report Share Posted January 7, 2012 I've used a standard .355Taper shaft in mine and it worked fine. Did you use a shim? That's what I had to do with the original TourAd UT shafts in the Cleveland Halo heads. Quote Link to comment Share on other sites More sharing options...
pickle Posted January 7, 2012 Report Share Posted January 7, 2012 Did you use a shim? That's what I had to do with the original TourAd UT shafts in the Cleveland Halo heads. No, straight install of a Nippon shaft, no issues with it...... Quote Link to comment Share on other sites More sharing options...
wmclarenf1 Posted January 8, 2012 Author Report Share Posted January 8, 2012 No, straight install of a Nippon shaft, no issues with it...... Just to reconfirm, yours is the new EGG I+ and not the older EGG irons? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.