Posted December 21, 201212 yr comment_194612 Just broke my 8 iron shaft , is it possible to use my 4 iron shaft tipped to 8 iron length ?
December 21, 201212 yr comment_194630 Flex would not even be close. As with most high end shafts, tip tipping is not recommended. Compare/match up graphics and see if butt trim is the way to go I'm not an expert in this field but I do believe I'm right on this one... Anyone else?
December 21, 201212 yr comment_194638 In theory, you might/should be able to (always good to double check with the manufacturer or experts). The tip size of the 725is are listed as parallels (.370). Taper tips (.355) are a whole different story...
December 22, 201212 yr Author comment_194675 Flex would not even be close. As with most high end shafts, tip tipping is not recommended. Compare/match up graphics and see if butt trim is the way to go I'm not an expert in this field but I do believe I'm right on this one... Anyone else? I was comparing the graphic , if I tipped my 4i shaft by 2 inches , it is to 8i length n all the graphic are in line . It 0.37 tip and was wondering is the shaft if tipped will perform to actual 8i . Thanks for all feedback
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.