Posted July 28, 20168 yr comment_259825 Hi Guys, Great forum. Dumb question but is there a way to un-hot melt a driver head? I bought a driver that was hot-melted and I can't hit it to save my life. I'm thinking my swing speed of 95-100 might not be enough as the driver launches very low and distance is very short. As always, thanks
August 8, 20168 yr comment_259977 Not an expert at all, but i think this is impossible to do, since the glue was injected into the head. How to "un-inject" the hotmelt I don't know, sounds impossible without really damaging the head
August 8, 20168 yr Author comment_259981 Thanks Vegaman, I've read that a solvent or sometype can be poured into the head which will dissolve the hot-melt. I really don't want to damage the head. I'm just worried that the head I have now might be normal and I just can't hit it. Just don't have enough experience with drivers that are hotmelted
August 15, 20168 yr comment_260075 Heat the head up on the base of the club doesn't need a lot at all and the hot melt will turn runny and you will be able to get it out via the hozel. but then you will need to really clean the bore bore shafting again. even a foam head can be removed but wouldn't advise trying unless you are a persistent bugger. Good luck
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.