lefty19

The ZR-600 has the same offset as the 506's except for the 7 irons, the 600 has more progression. David

What is the offset specs compared to the 506? Does these show an improvement over the 506? Am I to assume they come in LH? Thanks, David

Gentleman, I play Srixon 506's currently and am very happy with the irons except the fact that they have a little more offset than I would like... My question is, Who offers a quality LH forged iron that is as forgiving( Or close to) but with less offset than the 506 with the topline line or close to the 506? I like the Japanese offerings, beautiful lines etc... but LH is always my set back. Thanks, David

any pics of the 1061? Thanks, David

The subject explains it all. I need them for a set of X-16's. It does not matter 2-pw or 3-lw. Thanks, David

What models does it fit? I'm looking for a cover for a Baby Bee. Thanks, David

I am looking for a LH Bettinardi Baby Bee putter. Any offers!!! Thanks, David

I found a guy in my area with a launch monitor to figure out what kind of shaft I need for my 9.5TM360XD. In it is a Grafalloy Prolite 3.5 stiff. I used the ball I typically play with, a ProV. Averages were done by 28 swings, throwing out the 3 highest/lowest of the group. 1.ball speed:183mph 2.clubhead speed:126 mph 3. 13.6* launch angle (Guy said that was terrible) 4.something to do with Apex?62 yds. 5.side spin he said was good, he said it stayed around +/- 300 rpm. 6.ball spin 4460rpm's( guy said that this was terrible as well) 7.He said something about smash factor was 1.45, and could be a tad better? 8.avg carry:288 yds 9.avg roll:6yds 10.I wrote all this stuff down to make sure I got a/an opinion!!! He suggested I go with a 7.5 983K or a 8.5 983E driver with a good quality shaft like a NV 75X or some Fuji shaft he had. I would like to stay with the TM, but can a shaft make enough difference to get the ball speed down and the launch angle better? I have an old Ping TiTec 7* I could break out of the closet and do some tests with? Is this guy trying to get me to buy another driver? Any thoughts would be appreciated! David

Don't laugh: YOU did say any blade I have a set of Palmer Standard Blades 2-PW in 9.0+ condition. I have them only b/c my uncle had them as a back up and probably did not play 3 rounds with them. I have never hit them. Original stiff shafts and grips! PM if you want them CHEAP!! David

Interested in the VTLT PM sent