Search the Community
Showing results for tags 'tour120'.
-
IMPORTANT QUESTION: I just bought a set of mint condition irons that were built for someone else's specs, and am trying to work out how I am going to alter them to meet my own specs. These irons have Nippon modus3 Tour120 stiff shafts that I would like to keep, if possible. My problem is that I do not have enough practical knowledge about the modus3 Tour120 shaft, and there's not enough info on its webpage. So.. since I bought a set that was built for someone else, it is +1.0" longer than I need it to be, although it is the proper weight and bend profile; however I was fit to 6.5 iron shaft frequency (which can be achieved by hard stepping a Tour120 stiff shaft 1x) which is perfect for the X or TX flex, but not the S flex which needs to be hard stepped once to achieve a 6.5 frequency. My plan is to remove the heads and take -0.5" from the tip and also -0.5" from the butt.. but here is my problem: since I am going to be pulling these shafts, I do not know if they will THEN be able to be tipped -0.5" and still fit the iron heads. If these were 0.370" parallel shafts I know this wouldn't matter at all and I could do exactly that, but since they're 0.355" taper tip shafts and they've already been installed once I'm not sure if they'd still be able to be tipped -0.5" more, or even at all, and still fit the iron heads. So...…… my question is whether or not anyone has any knowledge that could be relevant to helping me get this set built to my specific specs: 6.5 iron shaft frequency, -0.5" from std length, std lie/loft. I am trying to achieve that result from the spec of the current set: standard Tour120 stiff flex frequency (unknown), +0.5" length from std. If anyone can offer any sage advice I'd greatly appreciate it. Thanks very much. Drew G