markooo Posted April 28, 2005 Report Share Posted April 28, 2005 Just picked up a set of Dunlop Seve B. blades. The shafts have pins whigh enter from one side. I have seen the sets with pins that can be pushed through when there are holes on each side but how do you deal with these when they can not be pushed through...that is if I want to put in new shafts? Thanks,Mark. Quote Link to comment Share on other sites More sharing options...
NickBooras Posted April 30, 2005 Report Share Posted April 30, 2005 If they can't be knocked out with a punch, I usually use a long (48") drill bit I have to drill through the pin, then I use a punch to knock the now seperate pieces inside the shaft. Good luck. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.