Posted April 28, 200519 yr comment_92501 Just picked up a set of Dunlop Seve B. blades. The shafts have pins whigh enter from one side. I have seen the sets with pins that can be pushed through when there are holes on each side but how do you deal with these when they can not be pushed through...that is if I want to put in new shafts? Thanks,Mark.
April 30, 200519 yr comment_92753 If they can't be knocked out with a punch, I usually use a long (48") drill bit I have to drill through the pin, then I use a punch to knock the now seperate pieces inside the shaft. Good luck.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.