Length of taper shaft set

[chiuyaa]

I went to golfsmith today and asked about to reshaft my MP30 with DG SL, but they said its not available in store and I may order it from web site.

Just wondering what kind of length of shafts I should buy for standard P-3? Someone said I should by 2x37" (for P & 9) and 37.5", 38" ... 40" (for 8 to 3).

Is that correct?

BTW any comment of this shaft?

thanks,

[Lowpro]

half inch increments for all 3-9iron, pw,sw,lw,gw all can be the same length 37''.. your on the right track..

and yes-- good shafts.. different feel -- more silky feel to them but still have that nice control of the DG's.............. :cool:

[chiuyaa]

Thanks ...

But the 9 iron should be 37.5" instead of 37", right?

[Lowpro]

yep------ sorry

[NickBooras]

Thanks ...

But the 9 iron should be 37.5" instead of 37", right?

No. The 9 iron uses the same raw shaft as the wedges. A 3-PW set will require a 40, 39.5, 39, 38.5, 38, 37.5, and two 37's.

When selecting taper tip shafts, remember this: The longest shaft available is always the 1 iron shaft. For Dynamic Golds, they are made 37"-41". The 1 iron shaft is the 41", and you go in 0.5" increments on down. For TT Lites, they are made 36"-40", so the 40" is the 1 iron shaft, and you go in 0.5" increments on down.

[plus1]

after installing the shafts ...then you cut to length ie, a 5 iron shaft installed raw will be 39, so you cut it to 38? is this correct.....

[NickBooras]

after installing the shafts ...then you cut to length ie, a 5 iron shaft installed raw will be 39, so you cut it to 38? is this correct.....

Correct. The finished length of the club has no impact on what raw shaft length you choose. Shaq and Mini-me would use the same length raw shaft, assuming they both play the same flex.