ScottyGilbert Posted July 20, 2007 Report Share Posted July 20, 2007 Guys and Gals, Im looking to install an Ozik XCon 7 into a Cally FT-5 head. What would the standard tipping be to make it play true to flex? Thanks in advance Scotty Quote Link to comment Share on other sites More sharing options...
SingleDG Posted July 20, 2007 Report Share Posted July 20, 2007 Guys and Gals, Im looking to install an Ozik XCon 7 into a Cally FT-5 head. What would the standard tipping be to make it play true to flex? Thanks in advance Scotty I'll be interested in the response, as well. I am looking hard at FT-5 tour head. Quote Link to comment Share on other sites More sharing options...
rb2235 Posted July 20, 2007 Report Share Posted July 20, 2007 (edited) I have heard that you tip a 1/2 inch but also heard that is not the case. I have a had a few matrix and installed all of them untipped and they played true to flex. They went into TM heads which if I am not mistaken is shallower than Cally. I would install untipped. They were all stiff flex and CPM'd in the mid 250's just as the sticker on the butt stated. Edited July 20, 2007 by yourpressed Quote Link to comment Share on other sites More sharing options...
Lowpro Posted July 27, 2007 Report Share Posted July 27, 2007 no tip trimming.. at 45'' it will play out fine.. any longer and yes you may wish to tip it some. hope this helps.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.