Jump to content

ALL NEW TOURSTAGE X-Drive Driver


gocchin

Recommended Posts

Tourstage has released an all new all black 445cc version of their X-Drive driver.

The target audience is lower handicappers looking for a smaller more solid feel. They recommend swing speeds of 100mph and above for this driver.

g0926_xdrive_001.jpg

It is longer front to back but less potruding in the heel area to give it more of a pear shape.

g0926_xdrive_002.jpg

The face is shallower and is considerably longer heel to toe.

g0926_xdrive_003.jpg

Comes with a special Tour Design Diamana shaft:

g0926_xdrive_004.jpg

Carbon red pearl like finish on the crown:

g0926_xdrive_005.jpg

Tested to produce far more carry than the X Drive 460, due to it's lower center of gravity and higher trajectory and lower spin (Orange bar is carry):

g0926_xdrive_007.jpg

Available in 9.5 and 10.5 lofts.

Link to comment
Share on other sites

  • Replies 53
  • Created
  • Last Reply

Top Posters In This Topic

The finish is great. Is this a fade bias driver like the 430P and the 460P? If so is the bias aimed in between or is it severe like the 460P?

Link to comment
Share on other sites

Face angle is square on this driver, not fade biased bit made to go straight.

It's interesting they actually describe the crown as black ion plated with a red spider web like design.

Link to comment
Share on other sites

I'm getting closer and closer to making my first purchase of a TS driver, they keep getting better! God knows the irons are nice. I'm a fade bias guy so I too wish they made the 460P in 10.5*. Problem is when you open a driver face up and the actual loft is 9.5* it ends up in the 8* range which is kinda tough for mere mortals (especially short ones like me!). Chris you have there ear, what do they say?

Link to comment
Share on other sites

After doing research on this club, it turns out that it's already in play on the JPGA by Hideto Tanihara and Yusuke Miyazato, Tourstage's two big young guns.

The stock B07-05 Tour Design shaft is in fact the Tour Only Diamana BLACK prototype. Mid kick, low spin, 2.8* of torque with a bend profile right between Blue and White. Looks like a winner.

Link to comment
Share on other sites

  • 2 weeks later...

Some live pics of the new TS stuff which is starting to get coverage in Japan... looks pretty awesome! Though the driver is not quite black... it's more like gunmetal....

h2.jpg

h2.gif

photo-1.jpg

photo-2.jpg

photo-4.jpg

photo-6.jpg

Link to comment
Share on other sites

Looking good......so many great irons to choose from.

Like the color scheme of the Tourstage X-drive...... :tsg_smiley_bulb:

Link to comment
Share on other sites

that xblade 3 iron looks mighty interesting. can someone explain the advantage of that screw?

That's actually the new Utility Iron. The screw is most likely a tungsten insert lowering the center of gravity, thereby increasing the ball flight.

Link to comment
Share on other sites

That's actually the new Utility Iron. The screw is most likely a tungsten insert lowering the center of gravity, thereby increasing the ball flight.

Friend here 'confirmed' that... ie he read something online and said 'hai, tungsten desu.' Actually, these pictures of the iron and utility make them look a bit more appealing. However, have you guys seen pictures of the top of the driver? From the photos I found this week it looks a bit like the top of the new TM Burner... a bit less traditional than I was hoping for, although I'll reserve judgement until I can actually see one.

Link to comment
Share on other sites

That's actually the new Utility Iron. The screw is most likely a tungsten insert lowering the center of gravity, thereby increasing the ball flight.

cool! im actually looking for a new utility iron. i used to use the ping fli hi irons 3/4 then switched to the mizuno mp fli hi then replaced them to hybrids. im actually considering the new on/off driving irons but these look so much more apealing to me.

Link to comment
Share on other sites

Also placing a tungsten weight towards the toe helps eliminate hooks and pulls. It's meant to keep it toe weighted and face open for more workability and fade bias...

Link to comment
Share on other sites

Why would one play a driving or ut irons (unless you are a low single) when you can play an easier wood like hybrid or fairway wood? These things are so unforgiving. The name of the game is to lower one score/handicap isn't it?

Link to comment
Share on other sites

Why would one play a driving or ut irons (unless you are a low single) when you can play an easier wood like hybrid or fairway wood? These things are so unforgiving. The name of the game is to lower one score/handicap isn't it?

True, but the driving iron has been popular in Japan for sometime. TourStage probably just wanted to capture that market and also for those who like the look of an iron as opposed to the utilities. Not everyone has embraced their (utilities') advantages. I've also noticed that TourStage loves the tungsten insert. They seem to putting that in all kinds of irons. Even my X-blade 2's have a tungsten insert in the 3,4 and 5 irons and they're blades! I think with this driving iron, TourStage just was looking to make a more forgiving version and appeal to those who identify with the reasons I stated earlier. Just my take.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...