Need Shaft Advice

[dhorlander]

I want to re-shaft a XR-03 10.5° (Japan with TM-Plus S).

However, I cannot find any specs on this driver. The shaft label noted SW was D-1.

I noticed that most have installed shafts in the 70g-77g range.

Is it because the head is very light? (versus R580 or R580XD)

Any recommendations or comments would be appreciated.

[+TourSpecGolfer]

I want to re-shaft a XR-03 10.5° (Japan with TM-Plus S).

However, I cannot find any specs on this driver. The shaft label noted SW was D-1.

I noticed that most have installed shafts in the 70g-77g range.

Is it because the head is very light? (versus R580 or R580XD)

Any recommendations or comments would be appreciated.

You dont need any specs to re-shaft the driver, and no the head isnt any lighter than others on the market. The TM Plus shaft that came stock with it is about 50-55 grams. To most people i suggest shafts in the 60 to mid 70 gram range.

[Lowpro]

the right shaft depends on your game.. do you know your swing speed,ever had a launch monitor session, these are very helpfull in getting the right setup.. if not what other driver setups have you hit that worked, your irons and shafts in them, best iron and yardage you hit it, how far do you carry the driver.. just few questions to see where to start with in looking for shafts,, normal ball flight and typical pattern.. left to right or ... many many shafts out there***

ken

[dhorlander]

Thanks for clearing things up.

I was fitted last year thus the reason for the YS-6 & 569 TS in both of my drivers. Just got confused with the XR-03 since it was never released in the States.

I will note your response to my stupidity was much kinder than what I'd expect to receive from "somewhere else".

If anyone has any info on the playing characteristics of the XR-03...it would be appreciated.