mizunofan99 Posted August 15, 2006 Report Share Posted August 15, 2006 I recently purchased a 48" version of the Redboard (Ion, Flowerband) and I obviously want to make sure I install it correctly in my 3-wood. This is not a bore through head (Adams 4060 Tour head actually). Do you just cut 2" off the tip and then butt trim it to the required length? What would be the final shaft length prior to installation? As you can probably tell, I'm new to clubmaking and I can't afford to mess this up so I would appreciate any guidance you experts can provide. Thanks in advance for sharing your expertise!!! Quote Link to comment Share on other sites More sharing options...
Lowpro Posted August 20, 2006 Report Share Posted August 20, 2006 not 100% sure on the red board tipping instructions.. go by what the company says to do.. if it says 2'' than tip cut it 2'' and install.. after drying.. mark at 43'' or what ever length you want to make it -- butt trim for length.. have the proper epoxy,ferrule than your set.. have fun. Quote Link to comment Share on other sites More sharing options...
Tomba29 Posted January 30, 2007 Report Share Posted January 30, 2007 Where do I find the information on tipping a Red for a fairway shaft? Quote Link to comment Share on other sites More sharing options...
+TourSpecGirl Posted February 1, 2007 Report Share Posted February 1, 2007 Where do I find the information on tipping a Red for a fairway shaft? Stiffer Performance for Driver and Standard Performance for Fairway wood: Blind Bore - ½" Tip. Bore Through - No Tip. Insert shaft to 2" depth. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.