Aluinser

If you find out, please let me know as well. Custom Clubmakers - I will only go to them for emergency situations. Quite frankly, they can't even regrip to the proper sizes and instructions. At this moment, I am quite tempted to just send everything across to the US for repairs/modification. It is costly, but if no one can do the job here, there's no point.

I'm ready right now....and I have been looking for you...please check pm

I have the following 3 clubs with s-fx shaft but want to cut it down to play like x-flex. How much do I need to cut down? (1) Fourteen driving iron with NSPro S-flex 40.25" (2) TM Rescue Mid with S300 40" and 39" respectively. Many thanks.

...would like one in conditions of 9/10+

Chris - I have a PM for you

I had a 3 and a 5. Too blasted tough for me to hit consistently. I had the HKpro-80's in them too. It's like the little evil sisters to the Maru US Spec Driver. Beautiful but... bitches. :mad: Is it due to the tiny clubhead?

Anyone here that could share their experience on this 3 wood with me? Thanks.

The RC driver is a very expensive piece of equipment, much more than the X-Drive. Would certainly be interested in your comments. Which shaft option did you go for?

Pics for reference

If pictures are available please send to [email protected] Cheers, Possible to pick up in HK? I prefer to do everything via Paypal and through the post.

Interested in these - would you have pics of the clubs? If so, pls send to me at [email protected] Is your price of $250 inclusive of shipping - I see that you are located in Hong Kong. Thanks Will get some photos within the next 12 hours or so. Price does not include shipping, but I do have very economical rates from Fedex. Where do you live?

As above looking for US$250. Minimal use, minimal dings if any, extremely well kept, everything standard, Jap spec model of course.

SOLD!

Give us a rough idea of the $ value please

Chris - what is the length?

As above, in steel shaft, preferably X. Actually, heads only are fine, but it must be in pristine conditions, original without any touch ups. Please PM me and forward pics and asking price.

around US$40 via speedpost

Will - I'll do that in a few hours.

Too many sets of irons, this set must go. Rarely played. Since I live in HK, I will lower the price to offset the shipping cost. US$350 PM if interested.

any photos of the actual putter? please pm me

Any pictures at all?

It cost around US$550. I have a set still in the plastic wraps. My intent was to weigh the refinishing cost against the cost of the original set, and of course benchmarking against cost of other things. If I have more than one set then I would probably go for it, but it's a hard decision, not just financial. If you have to ask....Then you don't want to know. :money: Great stuff. Especially the hologram. No offense intended but, how much do you think it cost for limited V.2 wedges. The stripping, re-plating, labor finishing, polishing, and PITA removal and replacement of the Hologram logo by Joe K? That's not even counting the Spine and flowing of the wedge shaft. The work is phenomenal.

That's a great attitude. Would love to see how loaded you are...... If you have to ask....Then you don't want to know. :money: Great stuff. Especially the hologram.

Is this a costly exercise?

Single strap only...