All,

Reshafting a couple of JDM wedges and it seems like the standard usdm ferrule outer size is slightly smaller than the JDM hosel size, does anybody else find this?

Does anybody know a good place to get ferrules that fit properly (UK/eu preferred)

Thanks

Sent from my D6503 using Tapatalk

All, Reshafting a couple of JDM wedges and it seems like the standard usdm ferrule outer size is slightly smaller than the JDM hosel size, does anybody else find this? Does anybody know a good place to get ferrules that fit properly (UK/eu preferred) Thanks Sent from my D6503 using Tapatalk

There isn't really a standard ferrule size with so many types and different sizes on the market.

Your clubmaker should be able to turn down the ferrule to fit and look good on your clubs.

I need to do this too. Can you recommend a good way or product I can buy to slim the outer diameter of the ferrule?

I need to do this too. Can you recommend a good way or product I can buy to slim the outer diameter of the ferrule?

Yes thin strips of sandpaper + steel wool and acetone, tape the head neck and shaft up and be careful.

Yep the sand paper is the cheapest and easiest way, Use wet and dry sand paper....wet, very smooth finish and not as harsh on the taped neck and shaft.

You will need a vice clamp.

If it hangs over just a little get a microfiber cloth and use acetone. Just set the butt on the ground and then spin the club and hold the cloth with acetone on the ferrule. It'll slowly melt away. Use a good microfiber cloth bc cotton shirts will leave the cotton fibers.